Thank you new Patreon supporters! Thomas Walz, Scott Fletcher, Cory Phillips, Mark Rinella, Brandon Hampton, and kitegem. Visit Patreon.com/KnifeSteelNerds if you want to support knife steel research.
Video
New video where I searched for “How To” heat treating video and evaluated them. How good (or bad) is the advice? Watch the video to find out.
Great video! I am actually positively surprised by the knowledge of those knifemakers, even though none of them is on your expert level of course 😀
I have a question about how much cerakoted effects the heat treat. I would like to get a knife cerakoted with elite series cerakote . This is oven cured at 300 degrees for 1 hour. The knife steel is REX76 .Will this hurt the heat treat? Will it change anything ? Mess with the temper?
300°F wouldn’t affect the heat treatment of Rex 76.
Thanks for sharing this helpful guide about of How to Heat Treat.